1. Pay attention to the role of the gasket. The gasket between the components of the tanker standing position plays a role of leakproof sealing. If the materials, production quality and installation do not meet the technical specifications, it will not achieve the sealing leakproof effect. Even accidents such as oil pans or valve covers, due to the large contact area and difficult compaction, resulting in oil spills.
2. All types of fastening nuts on the tanker must be tightened according to the specified torque. If the gasket is loose, the gasket will leak; if the tightening is too tight, the metal around the screw hole will be raised or the thread will cause the oil to leak. In addition, if the oil pan oil drain plug is not tightened or loosened, it will easily cause the loss of oil, and then the occurrence of "burning tile holding shaft" machine damage accident.
3, timely replacement of failure seals. A lot of moving parts of the tank car will be due to improper installation, journal and oil seal blade heart, yaw and throw off oil. Some oil seals used for too long will lose elasticity due to rubber aging. Leakage should be updated in a timely manner.
4, to avoid check valve, vent valve blocked. This causes the temperature inside the enclosure to rise, oil and gas to fill the entire space, the emission does not go out, so that the pressure inside the enclosure increases, the increase in lubricant consumption and replacement cycle is shortened. Engine ventilation system After plugging, the resistance of the piston is increased, so that the fuel consumption is increased. Due to the effect of the pressure difference between the inside and the outside of the casing, oil leakage may be caused in the sealing weak point. Therefore, the oil tanker must be checked, dredged and cleaned regularly.
5ã€Properly solve all kinds of oil tanker joint seals for tanker trucks. Vehicle joint nuts often disassemble and disassemble, easily slide wire breaks and loose, it will cause oil leakage. Replace the union nut, use grinding method to solve its cone surface seal, To tighten the nut and solve the seal.
6, to avoid wheel hub oil rejection. Tank wheel hub bearings and cavity too much grease, or its oil package is not properly equipped, poor quality and aging failure; frequent brake wheel hub temperature is too high; axle nut loose, etc. will cause the hub Rejection of oil. Therefore, use "cavity lubrication method" to clear the ventilation hole.
Waterproof Enclosures Box， Waterproof Box，waterproof enclosure，outdoor enclosure waterproof
wybox inc. , https://www.wybox-inc.com