What are the methods for using explosion-proof floodlights?

Posted on

The explosion-proof floodlight is a point source that can be uniformly illuminated in all directions, and the illumination range can be adjusted arbitrarily. Explosion-proof floodlights are used in hazardous areas where flammable gases and dust are present. They can prevent arcs, sparks and high temperatures inside the lamp from igniting flammable gases and dust in the surrounding environment, thus achieving explosion-proof effects.
Explosion-proof floodlights
First, according to the actual needs of the work site, determine the installation position and installation method of the lamp, and then prepare the corresponding length of Φ8-Φ14 mm three-core cable according to the distance from the lamp to the power contact.
Second, open the ballast end cover, loosen the compression nut of the ballast cable inlet, and introduce the lamp cable and power wire through the compression nut to the internal terminal of the ballast to fix the connection. Tighten the cable tie nut and tighten the ballast cover separately.
Third, according to the determined installation position and installation method, the lamp and the ballast are installed, and then the other end of the ballast input cable is connected to the 220V power supply according to the explosion-proof requirement, and the illumination can be realized.
Fourth, loosen the screw at the bottom of the lamp holder, and adjust the illumination orientation by 360° rotation of the lamp holder. Loosen the screws on both sides of the lamp holder, adjust the illumination angle of the lamp head up and down according to the lighting requirements, and then tighten the screws.
Fifth, when replacing the bulb, use a suitable screwdriver or other tool to insert the hole in the two convex parts on the side of the front cover, unscrew the front cover, remove the bad bulb, and replace the new one.

Landini was founded in Italy to manufacture agricultural equipment in 1884, but till 1925, Landini tried to make the tractors. But in 1989, Landini was sold a part of their business to ARGO, and after that, they only produce some tractors for AGCO. So the parts needed in the market are few. Some of the parts like shut down solenoid, starter solenoid, starters,  air filer, fuel flter, oil filter, hydraulic filter, air compressor can be supplied by us. If the parts you can't find on our website and other suppliers, you can contact and tell us, then we could help to give you a good solution.

landini tractor spare parts

Landini Aftermarket Parts

Landini Aftermarket Parts,Aftermarket Landinia Parts,Landini Skid Steer Parts,Landini Equipment

Hangzhou Holdwell Mechanical&Electrical Co.,LTD , https://www.holdwellparts.com