At present, most of the domestic inlet test uses high pressure ejector and vacuum pumping, but these schemes have short effective test time, require high pressure gas source or air compression equipment, long experimental preparation time and high experimental cost. . In order to meet the requirements of the 5.45Kg/s mass flow of the inlet of the modified inlet of a certain type of aircraft, we have demonstrated the experimental scheme of two centrifugal fans for series pumping. Inlet test serial fan suction scheme introduction According to the needs of future experimental tasks and comparative analysis with the brother unit equipment, the experimental scheme of the inlet port with two centrifugal fans is selected. Reducing the loss of the pipeline is the key to improving the suction characteristics. We have taken the following measures: 1) minimizing the length of the connecting pipe; 2) adopting a slow transition method at the bend; 3) treating the relationship between the expansion angle and the length during the expansion 4) Use the FM power supply to control the fan speed to change the inlet flow, and no longer use the valve in the pipeline.
Estimation of the loss of the suction pipe system Since the pipe inside the suction is relatively smooth, the total loss along the path is =0.05. The air inlet experimental system can provide a mass flow rate of 5.81Kg/s in a windless state, and can provide a pressure rise of 13000Pa, and the flow coefficient can reach 0.90, indicating that the system has fully realized the design index, and also shows the second type. The pipeline loss estimation method has certain reliability. Through the above simple explanation and preliminary analysis, the following conclusions can be made for the new system: l) The system can continuously pump gas, accurately control the flow, and the data collection is convenient; 2) The system has less loss; 3) The system is easy to install and cost Low, the fan can also be used in other experiments, reducing the idle waste of the experimental equipment; 4) can provide a large flow, can more effectively simulate the inflow of the inlet. However, the system still has the disadvantage of large noise, and we will continue to improve, so that this new system can more effectively serve the air tunnel wind tunnel experiment of our aircraft.
Hard turbine speed door: set energy-saving insulation and efficient wind environmental seal in a new metal industrial doors , opening speed of up to 1.5meters per second , For applications that require frequent rapid opening of the logistics channel , Insulation thickness 0.7mm aluminum door intermediate polyurethane foam , total thickness 40mm door wide 185mm per meter weight 1.63KG, Having good thermal insulation and light weight impact strength and other characteristics , wind rating of greater than 12 and theft , The door is suitable for indoor and outdoor fast-track logistics and production , The door type for enterprises save a lot of energy due to air flow generated loss than ordinary industrial sliding doors shutter doors save energy about eighty percent , Rapid opening and closing of the door so that enterprises in the rotational speed of the production and logistics of the door is greatly improved enterprise logistics and production must pass through the channel selection and its use is directly related to the efficiency of production and logistics , This product has high reliability , practicality and easy operation and quick fix for me , Drive control using a stable energy-effcient and accurate hard to guarantee fast and reliable operation of the door system the door to ensure trouble-free operation every year more than 250,000 times
Turbine Hard High Speed Door, high speed spiral doors, aluminum high speed turbine door, Aluminum Rapid Door, Aluminum Fast Door
SHENZHEN HONGFA AUTOMATIC DOOR CO., LTD , https://www.hongfafrs.com