How to maintain and operate the magnetic separator?

The following points should be noted when maintaining the magnetic separator:

1) Maintaining a good lubrication state is an important part of extending the service life. The open gear should have sufficient oil and the oil hole on the bearing cap should be filled at least once every three months.

2) Always check the wear layer on the cylinder. The loose or broken head should be repaired in time. During the repair, the surface of the rubber strip and the cylinder at the broken end should be cleaned with sandpaper, and then the adhesive tape is firm.

3) what should be removed at any pulp or iron wire electrode head or the like, so as to the ore hours, with or without these things up, the cartridge will soon worn or scratched skin. Whether there is any foreign matter on the cylinder can be checked through the observation holes at both ends when parking.

Operation of the magnetic separator: drive the water before the mine; stop the mine before stopping. In normal operation, pay attention to the adjustment of the blown water and the unloading flushing water, and the adjustment of the magnetic declination.

Magnetic separation operators should often get in touch with the mill miners to keep abreast of the effects of changes in pulp concentration on magnetic separation.

Dust Mask Making Machine

Dust Mask Making Machine,Anti Dust Mask Machine,Automatic Dust Mask Making Machine,Cotton Mask Filter Machine

SINGSUN ELECTRONIC SCIENCE & TECH CO.,LTD , https://www.maskmachine.nl