Construction Machinery Diesel fuel pump failure causes and solutions:

Fuel injection pump is an important part of the diesel fuel system, the quality of its work directly affects the diesel engine power, economy and reliability. In the repair of individual repairman pay less attention to the fuel pump, resulting in some man-made faults. Here are just three cases for troubleshooting reference.

(1) A 6135k-9a diesel engine used in a zl50cii loader has no obvious fault during idling operation, but when it accelerates, the sound of "sudden protrusion" appears and the color of the exhaust smoke is white or black and unstable .

The beginning, that is, injection timing is wrong, but the fuel injection timing after readjustment, the fault still; check the low and high pressure oil, were found no problem. Finally, when removing the fuel pump, it was found that the lock nut at the tip of the fuel injector was loose and the keyway of the fuel injector and the camshaft of the fuel injection pump had been widened due to wear. The thickness of the semicircular key was less than half . Milling key again, installed after the failure disappears. It is understood that the machine's fuel pump has just been repaired not long ago, resulting in the failure of the direct cause is: Maintenance personnel installed in the extension of the fuel injector does not tighten the locknut torque required, so that when the engine speed control Due to the fuel injector ahead of the camshaft with loose Kuang and aggravated the keyway and the semicircle key wear and tear, resulting in fuel injection instability.

(2) a tl180 bulldozer used to load the 6135k-12c diesel engine, the fuel injection pump model is bh6b100ys490. In an engine overhaul, the fuel injection pump and injector are on the test bench were calibrated. The engine after running in, the bulldozers into the earthwork, then because of the engine work unable to work, and in the engine idling throttle, I feel bad acceleration.

After examination, the engine, fuel injection timing are normal, oil-free place, governor, fuel injection pump, low pressure and high pressure oil are also no problem, it is suspected that the school pump may be rated working condition fuel Tune too low due. As a result, the fuel pump removed and re-test on the test bed and found that it really is the school pump master wrong will pump the rated condition of oil reduced by 6ml / 200 times. Re-set the fuel pump back, test machine, the operation normal and powerful.

(3) A w4-60c excavator equipped with a f6l912 diesel engine suddenly goes off on its way to the worksite, but after several starts it does not start. Observe the exhaust situation, but no smoke, initially concluded that the oil fault.

Check, pump oil with a manual pump, the result is a good oil, the oil no leakage, clogging; swing speed handle, the fuel pump lever adjustment rod did not respond. When disassembled the governor, it was found that the connection between the oil supply lever and the governor lever was loosened and the pin was broken. Reconnect the fuel rod and governor lever, and lock with the new pin, start quickly when activated, indicating that the fault was ruled out. The reason for this failure is that the maintenance personnel did not replace the new pin as required while assembling the governor and still used the new unused and cracked pin to break the pin. The oil supply rod and the speed control lever Connection loose, resulting in failure to start.

More Search Keywords: Pumps

Swaco D380 Shaker Screen

Replacement Steel Frame Shale Shaker Screen for Swaco D380 shakers

SJ-Swaco D380 shaker screen is a popular type steel frame shale shaker screen for solid control equipment. The framework is made of high strength square steel tube or flat steel plate through welding process, finished with extra strengthening supporting tendons. Stainless steel 304 or 316 wire mesh cloth can be combined with the metal plate and frame or directly bonded on the frame. All screens were repairable with special rubber plug when screen surface damaged.

Technical Parameter

Mesh Material: stainless steel 304/316/316 L.
Frame Material: Q235 steel.
Screen Type: XL, XR.
API RP 13C Designation: API 20 â€“ API 325.
Color: green.
Package: packed in paper carton, shipped by wooden case.

Adaptable Shale Shaker Model

SJ- Swaco D380 shaker screens are used as the substitute screen for

Swaco D380 shaker
NOV Brandt D285P shaker

Competitive Advantage

Steel tubular frame with strengthening supporting tendons.
SS 304/316 wire mesh cloth does not rust or delaminate.
Resistant to fluids that shorten steel frame screen life.
Manufactured according to the API RP 13C (ISO 13501).
Scientific & reasonable cost control system for competitive price.
Adequate inventory in the shortest time to meet customers' demand.

Swaco D380, are mark of Varco I/P, Inc.

ShengJia only produces the replacement screens but not original from Swaco.

Swaco D380 Shaker Screen

Swaco D380 Shaker Screen,Swaco D380 Shale Shaker Screen,Shaker System,Mongoose Shaker

Anping Shengjia Hardware Mesh Co.,ltd , https://www.oilshakerscreen.com